4.
Remove the drive belt (B) from the lower redrive pulley.
5.
Remove the redrive assembly.
Note: When you reinstall the redrive assembly be sure to align the notch in the redrive assembly with tab (C).
Registration motor removal
See
page 7-17
1.
Remove the inner system board shield. See
2.
Remove the registration motor mounting screws (B), cut the cable tie (A), and remove the assembly.
Installation note: Be sure to replace the cable tie (A).
for the part number for the registration motor assembly kit.
"Inner system board shield removal" on page
5061
4-48.
4-83
Repair information