Table of Contents
Advertisement
5061
User attendance messages (continued)
User primary
message
57 Configuration
Change
58 Too many bins
attached
58 Too many disks
installed
58 Too many flash
options installed
58 Too many trays
attached
58 Input Config Error
59 Incompatible
duplex
59 Incompatible
output bin <x>
59 Incompatible tray
<x>
61 Remove defective
disk
62 Disk full
2-134
Service Manual
Explanation
This message are displays when the printer has attempted to Print and Hold jobs
from the disk and found that some or all of the jobs could not be restored. The printer
firmware could not restore jobs from the disk because the configuration of the printer
has changed. Some configuration changes that can cause a 57 Configuration
Change message are:
• Code version change
• Paper handling option removed
• Disk drive has been moved to a different printer.
Note: Some of the held jobs may not be restored. They remain on the disk, but
cannot be accessed.
1. Turn off and unplug the printer.
2. Remove the additional bins.
3. Plug in the printer, and turn it on.
1. Turn off and unplug the printer.
2. Remove the excess disks.
3. Plug in the printer, and turn it on.
1. Turn off and unplug the printer.
2. Remove the excess flash memory.
3. Plug in the printer, and turn it on.
1. Turn off and unplug the printer.
2. Remove the additional trays.
3. Plug in the printer, and turn it on.
This message is displayed when:
• An high-capacity input tray (HCIT) is connected when it is not supported (C770).
• More than one duplex unit is installed.
• More than one option tray (500-sheet tray, envelope feeder, or outdoor media
tray) are connected above the HCIT.
• The duplex unit and HCIT are installed without a tray.
• The duplex unit is located in the wrong location, for example if an option tray is in
installed above the duplex unit.
To fix the problem:
1. Turn off, and unplug the printer.
2. Remove the non-compliant input option or properly configure the printer options.
3. Plug in the printer, and turn it on.
1. Turn off and unplug the printer.
2. Remove the incompatible duplex unit.
3. Plug in the printer, and turn it on.
1. Turn off and unplug the printer.
2. Remove the specified incompatible output bin.
3. Plug in the printer, and turn it on.
1. Turn off and unplug the printer.
2. Remove the specified incompatible tray.
3. Plug in the printer, and turn it on.
• Press
to clear the message and continue printing.
• Install a different hard disk before you perform any operations that require a hard
disk.
• Press
to clear the message and continue processing.
Any information not previously stored on the hard disk is deleted.
• Delete fonts, macros, and other data stored on the hard disk.
• Install a larger hard disk.
Advertisement
Table of Contents
