Table of Contents
Advertisement
5061
POST incomplete—stapler cycles several times
Step
Actions and questions
1
Remove the stapler cartridge holder from the stapler
assembly. If the holder is jammed in the stapler
assembly:
1. Turn the printer off, and remove the right side
cover. Use care when removing the cover, as the
right side door switch and cable assembly are
easily damaged. Do not allow the right side cover to
hang by the switch and cable assembly.
2. Disconnect the 10-pin cable from the stapler
assembly.
3. Hold the stapler assembly with one hand while
removing the three screws from the assembly. The
assembly is heavy and easy to drop.
4. Check the stapler assembly for damaged or broken
parts. Check the flag and spring assembly on the
front of the stapler assembly to see if the flag or
spring are broken or missing.
Is the flag or spring broken or missing?
2
Carefully cycle the large gear on the side of the stapler
assembly, and try to free the cartridge holder
assembly. Note: Look for staples jammed at the throat
of the cartridge holder, and remove any that are found.
Gently try to remove the cartridge holder from the
stapler assembly. It may be necessary to manually
cycle the large gear on the side of the stapler assembly
to release the cartridge holder.
Reinstall the stapler assembly with a new stapler
cartridge holder and staples. Run the Finisher Feed
Test to check the option. See
on page
Does the problem persist?
3
Stapler to stapler board (J3) cable—Check the
continuity of the cable.
Is there continuity?
2-114
Service Manual
"Finisher Feed Test"
3-23.
Yes
No
Replace the
Go to step 2
broken or
missing flag or
spring.
Go to step 3
Problem resolved
Replace the
Replace the
stapler assembly.
stapler board
cable (J3).
Note: When
replacing the
stapler assembly,
observe the
location of the
ground lead from
the stapler
assembly and the
finisher frame,
and make sure
the ground lead
is correctly
reattached.
Advertisement
Table of Contents
