Receiver (A/V :Receiver) - Mitsubishi CS-40507 Owner's Manual

TV + home theater receiver (A/V receiver)
A home theater (A/V) receiver has video inputs and outputs and is
used to control an A/V system. See your receiver's owner's guide for
information about connecting VCRs and other equipment. If your
receiver does not have video inputs and outputs, turn to page 40.
equipment you will need
• one set of RCA pin-type audio
cables,
one RCA pin-type video cables
(to complete step 0 below), and
4
• either one S-video cable or one
RCA pin-type video cable to
complete step O.
Procedure
0
0
0
0
Connect one end of a video cable to the TV VIDEO INPUT
terminal of the home theater receiver. Connect 1;he other end of
this cable to the VIDEO TUNER OUTPUT terminal on the
back of the television.
Do ONE (not both) of the following:
• Connect a video cable to the VIDEO MONITOR OUT
terminal on the back of the receiw;r. ConnecL its other end to
the INPUT-1 VIDEO INPUT terminal on the television.
• Connect an S-video cable to the S-VIDEO OUT terminal on
the VCR. Connect the other end of this cable to the
INPUT-1 S-VIDEO INPUT terminal on the television.
Connect audio cables to the TV AUDIO INPUT terminal of the
home theater receiver. Use the red cable to connect the right
(R) channel and the white cable to connect the left (L) channel.
Connect the other ends of these cables to the left and right
AUDIO TUNER OUTPUT terminals on the television.
38 Chapter 2: Connecting Your TV