Table of Contents
Advertisement
_Important:
_Important:
procedure
(Please
see illustration
on the following
page.)
O
Connect
the incoming
cable or antenna
to the ANTENNA
IN
terminal
on the VCR.
Connect
one end of a coaxial cable to the ANTENNA
OUT
terminal
on the VCR.
Connect
the other end of the coaxial cable to the ANT-A
terminal
on the TV.
Do ONE (not both) of the following:
• Connect
a video cable to the VIDEO
OUT terminal
on the
back of the VCR. Connect
the other end of this cable to the
VIDEO INPUT
terminal
on the back of the television.
• Connect
an S-video cable to the S-VIDEO
OUT terminal
on
the VCR. Connect
the other end of this cable to the
S-VIDEO INPUT
terminal
on the back of the television.
Connect
audio cables to the AUDIO OIiIT terminals
on the back
of the VCR. Use the red cable to connect the right (1_'0 channel
and the white cable to connect
the left (L) channel.
O
Connect
the other ends of these
cables to the AUDIO INPUT
terminals
on the back of the television.
If your VCR is monaural
(non-stereo),
only connect
a single audio
cable. Connect
this cable to the VCR, then connect the other end of
the cable to the L (LEFT) audio input
on the back of the television.
If your VCR has a video channel
switch
with an "OFF" setting
or
an "AV" setting,
set the switch to that setting.
Begin playing
a tape of the VCR.
Use the INPUT button
on the control
panel or on the remote
control to select the input
(INPUT-1
or INPUT-2)
to which you
connected
the VCR.
Basic Connections
33
Hide quick links:
Advertisement
Table of Contents
