Mitsubishi CS-40507 Owner's Manual page 31

TV + cable with a decoder box
equipment you will need
Use this hook-up if you need a decoder box to descramble some of
your cable signals. When you complete this :aook-up, you should set
up your remote control to operate your cable box (see page 47).
To complete the hook-up, you will need:
• one two-way splitter, and
OUT OUT
three 75 ohm coaxial cables.
procedure
(Please see illustration on the following page.)
O Connect your cable system's incoming cable to the IN terminal
on the two-way splitter.
O Connect a coaxial cable to one of the OUT terminals on the
splitter; connect the other end of this cable to the ANT-A
terminal on the back of the TV.
Connect the second coaxial cable to tile second OUT terminal
on the splitter; connect the other end of this cable to the IN
terminal on the decoder box.
Connect the third coaxial cable to the CPUT terminal on the
back of the decoder box; connect the other end of thi:s cable to
the ANT-B terminal on the back of the TV.
Basic Connections
29