Mitsubishi CS-40507 Owner's Manual page 21

-7 ":
(_) select buttons
Your remote control has four layers: the
TV layer, the VCR-A layer, the VCR-B
layer, and the CABLE layer. You can set
up each of these layers to operate a
different piece of equipment. Use the four
buttons across the top of the remote to
select the layer you want to set up or use.
When you press a remote control button,
the lights above the select buttons will
indicate the layer you are using.
@)VCR buttons
Use these buttons to control most
Mitsubishi VCRs. They can also be set up
to control other brands of VCRs. The
PLAY button is also used with the Active
tJV Network Feature (see page 93).
(_) power button (POWER)
Use to turn the TV on or off. When you
turn the TV on, the power indicator will
light in green.
(5) mute control (MUTE)
Use to turn the sound off completely or to
restore it to its original volume.
®
:super quick view button (SQV)
:Press to view channels you have
programmed into super quick view
memory.
(_) quick view button (QV)
" Press this button to instantly switch to the
channel that you designated as the "quick
view" channel.
(7) light button
Use to light up the remote control (for 3
seconds).
(_'_1 volume control (VOLUME)
Press the top part of the button to turn up
the volume; press the bottom part of the
button to turn down the volume.
® input button (INPUT)
Use to select the input source you wish to
watch:
• Antenna A,
• Antenna B, or
• Input 1, 2, or 3.
®
channel control (CttANNEL)
Press the top part of the button to change
to a channel with a higher number'; press
the bottom part to change to a channel
with a lower number.
(_) enter button (ENTER / EXCH)
Use this button after selecting a channel
number or after selecting an item from the
on-screen menu sy,,;tem. You can also use
this button when operating the
picture-in-picture mode.
@ADJUST buttons (,i,, V,41, • )
After selecting an audio or video function,
use these buttons to adjust the function.
These buttons can be used to:
turn the function on or off (e.g., video
noise reduction),
increase or decrease the function (e.g.,
color),
shift from one end of a scale to the other
(e.g., balance), or
select a position (e.g., stereo).
You will also use these with the picture-in-
picture mode and to select items :in the
menu. system.
(_ cancel button (CANCEL)
This button is used Lo cancel a channel
number, to clear a channel programmed
into super quick _iew memory, and to clear
the settings of some on-screen menus.
@ menu button (MENU)
Use this button to display the on-screen
menu system, which contains additional
instructions for special functions.
Overview of the Remote Control 19