Mitsubishi CS-40507 Owner's Manual page 47

Using the remote control to operate cable boxes
and other brands of VCRs
operating Mitsubishi components
This TV's remote control has four "layers": the TV layer, the VCR-A
layer, the VCR-B layer, and the CABLE layer. Each layer can be
used to operate a different component in your A/V system. You
select the layer you want to use by pressing one of the "select"
buttons across the top of the remote control. The TV layer is
programmed to operate your Mitsubishi TV, and tile VCR-A and
VCR-B layers are prog:cammed to operate Mitsubishi VCRs.
The following buttons are available when using this TV set.
• power button
• pause button
• mute control
• super quick view button
• quick view button
• volume control
• input button
• channel control
• enter button
• audio and video controls
• raenu button
• cancel button
• display button
• home button
• off-timer button
• number buttons
• PIP controls
• PLAY button
• quick program button
operating cable boxes or other manufacturers' VCRs
If you have a cable box or a VCR t_om another manufacturer, you
can "set-up" the remote control to operate these components. The
VCR-A layer, VCR-B layer, and CABLE layer can each be set-up to
operate a VCR or a cable box.
setting up the remote control to operate your VCR
Turn off your VCR.
Press one of the select buttons across the top of the remote to
choose the layer you want to set up: VCR-A, VCR-B, or CABLE.
O
O
O
While holding in the POWER button on the remote control,
enter the code number listed in the chart on the following page
for your brand of VCR. Be sure to enter both digits of the code
number. If more than one number is listed, try the first one.
Release the POWER button
Press the POWER batton again. Your VCR should turn on. If
the VCR turns on, your remote control is now set to operate
your VCR.
46 Chapter 3: Operating Your TV