Mitsubishi CS-40507 Owner's Manual page 38

TV + VCR + cable with a decoder box (cont.)
_Important:
_Important:
procedure
O Connect the incoming cable of your cabLe system to the IN
terminal on the two-way splitter.
O Connect a coaxial cable to one of the OUT terminals on the
splitter; connect the other end of this cable to the ANT-A
terminal on the back of the TV.
_) Connect a second coaxial cable to the other OUT terminal on
the splitter; connect the other end of this cable to the IN
terminal on the decoder box.
O Connect the third coaxial cable to the OUT terminal on the
back of the decoder box; connect the other end of this cable to
the ANTENNA-IN terminal on the back of the VCR.
Connect the fourth coaxial cable _o the ANTENNA-OUT
terminal on the back of the VCR. Connect the other end of this
cable to the ANT-B terminal on the back of the _L_V.
O
Do ONE (not both) of the following:
• Connect a video c.able to the "VIDEO OUT terminal on the
back of the VCR. Connect the other end of this cable to the
VIDEO INPUT terminal on the back of the television.
• Connect an S-video cable to the S-VIDEO OUT terminal on
the VCR. Connect the other end of this cable to the
S-VIDEO INPUT terminal on the back of the television.
Connect a set of audio cables to the AUDIO OUT terminals on
the back of the VCR. Use the red cable to connect the right (R)
channel and the white cable to connect the left (L) channel.
Connect the other ends of these cables to the AUDIO INPUT
terminals on the back of the television.
If your VCR is monaural (non-stereo), on:[y connect a single audio
cable. Connect this cable to the VCR, then connect the other end of
the cable to the L (LEFT) audio input on the back of the television.
If your VCR has a video channel switch with an "OFF" setting or
an "AV" setting, set the switch to that setting.
Start playing a tape on your VCR.
_) Use the INPUT button on the control panel or on the remote
control to select the input (INPUT-1 or INPUT-2) to which you
connected the VCR.
36
Chapter 2: Connecting Your TV