Selecting; Chapter 4: Using - Mitsubishi CS-40507 Owner's Manual

Selecting the source of the PIP image
_Important:
When you first activate the PIP image, as described on tile previous
page, you will probably see the same picture in the small image as
yoa do on the main image. This is because both images have the
same "source." A "source" is any signal that your TV is receiving
through the antenna terminals or through the input terminals.
If you want to see a different picture in the PIP image, you need to
change its source. Since your main image is usually a signal being
received through an antenna terminal, you need to selecl_ one of the
input terminals as the PIP's source.
These instructions explain the most comraon way to see a different
picture in the PIP image: using a VCR connected to Input-1 as a
PIP source.
0 Turn your VCR on and select a
channel on the VCR that is
different than the channel you
see on your TV screen.
Press the SOURCE button on
the remote control repeatedly
until the VCR picture appears
in the PIP image
If you want to select a source
other than the VCR, continue
pressing the SOURCE button.
The source will change as
follows::
LTV---,Input-l-,Input-2-*lnput-3 -j
To change the main image while in PIP mode, press the input
button (INPUT) on the control panel or on the remote control.
88 Chapter 4: Using the Special Features