Mitsubishi CS-40507 Owner's Manual page 66

Adjusting the sound (cont.,)
The "Speaker" function allows you to play the TV_s sound through
the internal speaker or the external speakers.
• Choose "Internal" if you want to play the T_s sound through
the TV's built-in speaker.
• Choose "External" if you connected speaker,'; to the speaker
terminals on the rear of the TV, or if you want to play the sound
of your TV through an audio system.
The "Monitor out" function determines how the TV will send an
audio signal to an audio system or home theater receiver. Your
choices are '_v'ariable " or "Fixed."
• If you choose "Fixed," the TV will send out an audio signal at a
fixed volume level. The level will not change when you adjust
the TV's volume. Use the controls on your audio system to
adjust the volume. The "Fixed" setting is mo,;t useful when you
can control the audio system's volume with a remote control.
• If you choose '_Variable," the T_c's audio output will change
when you change the TV's volume. If you use this setting with
an audio system, turn the TV's volume all the way down, set the
audio system's volume to an average setting, then turn the TV's
volume up until you can hear the signal.
o O
adjusting the audio functions
When adjusting the audio
functions, you can use the buttons
on the remote control or on the
control panel.
Press the AUDIO button
repeatedly until the function
you want to adjust appears
on-screen. (The functions
appear at the center of the
bol;tom of the screen.)
While the function is still on the
screen, use tlhe ADJUST
buttons to adjust the function's
setting.
The functions will disappear
from the screen .after a few
seconds. (You cannot adjust a
function if it is not on the
screen.)
66 Chapter 3: Operating Your TV