Denon AVR-2805 Operating Instructions Manual page 85

• Recalling preset statiens frem the remote centrol unit.
I SHIF%
{Remote control unit}
Watching the display, press the
SHIFT button to select the preset
memory bbck.
2
CHANNEL
Watching the display, press the
CHANNEL + (UP) er - (DOWN)
button te select the desired preset
channel.
{Remote control Uilit}
• Recalling preset statiens frem the main unit's panel.
IENJS_ Press the TUNING PRESET butten.
TUNI
P
(Main unit)
Turn the FUNCTION kneb and
FUNCTION select the desired preset channel.
(Main unit)
6
5'6 5
v Au×
U
--1
--2
r_ LAST FUNCTION MEMORY
• This unit is equipped with a last fur_ctien memory which steres the input and eutput setting conditions as they were immediately before the
power is switched off.
This function eliminates the need to perform cemplicated resetting when the power is switched en.
• The unit is alse equipped with a back-up memory. This function provides approximately one week ef memory sterage from when the main
unit's power switch is eff and with the power cerd discennected.
r_ INITIALIZATION OF THE MICROPROCESSOR
When the indicatk>n of the display is not normal or when the operation of the unit does not shows the reasenable result, the initialization ef the
microprocesser is required by the following procedure.
Switch off the unit using the main unit's power eperatien
switch.
Hold the following INPUT MODE butten and ANALOG butten,
and turn the main unit's pewer operation switch en.
1,2
@@@@@_
Check that the entire display is flashing with an interval of
abeut 1 second, and release yeur fingers from the 2 buttens
and the microprecessor will be initialized.
NOTES:
• If step 3 does not werk, start over from step 1.
• If the microprecessor has been reset, all the settings are reset
te the default values (the values set upen shipment frem the
factory).
85