Denon AVR-2805 Operating Instructions Manual page 54

(1) System call buttons
Up to 10 signals each can be stored at the "CALL1 " and "CALL2"
buttens.
The accessorious remete centrol unit is equipped with "system call" function allewing a series ef remete control signals to be transmitted by
pressing a single button.
This function can be used for example to turn on the amplifier's pewer, select the input seurce, turn en the monitor TV's pewer, turn en the seurce
component's power and set the seurce te the play mede, all at a signal butten.
....
lm
DENON
RC-974
J
(2) Storing system call signals
1
OFF
ON/SOURCE
Press the power ON/SOURCE button and
the OFF button at the same time.
• The LEARNED/TX indicator flashes.
_ Press the CALL 1 button.
• The mode selecter buttons and
LEARNED/TX indicator flash.
Press the mode buttons of the equipment that is te be
registered to System Call.
CABLE
@
Press the buttons whese remete centrol signals you want te
store one by ene.
Repeat steps 3 and 4 te register the desired buttens.
_ Press the CALL1 or CALL2 button and
register System Call.
--1
NOTES:
• The remote centrol signals for the buttens pressed while storing the system call signals are transmitted when the buttons are pressed, so
cover the remete senser or take other measures se that the components de not operate while the signals are being stered.
• The mode butten and LEARNED/TX indicator flashing rapidly if you have already stored the maximum number of signals.
54