Denon AVR-2805 Operating Instructions Manual page 68

I'_ SURROUND
• Before playing with the surround function, be sure te use the test tones to adjust the playback level frem the different speakers. This adjustment
can be performed with the system setup (see page 32-34) or frem the remete control unit, as described below.
• Adjusting with the remete control unit using the test tenes is only possible in the "Aute" mode and enly effective in the STANDARD
(DOLBY/DTS SURROUND) modes. The adjusted levels fer the different medes are autematicallv stered in the memerv.
% Press the TEST TONE button.
{Remote control unit/
2
Test tones are output from the different
speakers. Use the channel volume adjust
buttens to adjust so that the volume ef
the test tones is the same fer all the
speakers.
(Remote control unit}
%
After cempleting the adjustment, press
the TEST TONE button again.
(Remote contlol unit}
'6' o%
--i pUT_
1,3 i _.,L_ _ _
[ 0 DENON
RC-974 J
• After adjusting using the test tones, adjust the channel levels either according te the playback sources or te suit yeur tastes, as described below.
1
2
Select the speaker level yeu want te
adjust.
(Re]'notecontrol unit/
The channel switches as shewn below each time the butten
is pressed.
G
(Remote contlol unit}
Adjust the level of the selected speaker.
m
I m
SYSTEM _A 6 6 R
S_TUp _ENU_
_ISP_A_ R_TUa_
-I_PUT--
_S_t_RN
© DENON
RC-97¢
_ J
•_ When the surround back speaker setting is set to "lspkr" for
"Speaker Configuration", this is set to "SB".
NOTES:
• The adjustment range for the different channels is +12 dB to
-12 dB.
• The sound from the subweefer can be cut by lowering the SW
(subweofer) setting one step from -12 dB (setting it te "OFF").
68