Denon AVR-2805 Operating Instructions Manual page 21

The Auto Setup function of this unit performs an analysis of the speaker system and measures the aceustic characteristics of your roem to permit
an apprepriate autematic setting.
._ When performing Auto Setup, an eptional microphene is required fer the setup.
• Measurement and setting details
_1};: This sets the speaker connection mode, polarity, and bass reproduction ability.
12} : This sets the optimum delay time from each speaker correspending to the listening pesitk>n.
13; : This sets the volume that is eutput from each speaker.
_4} : This sets the frequency response of each speaker.
NOTE:
• A loud test tone is eutput during the measurement. Please consider this should yeu be planning night time measurements, and consider net
allowing small children into the listening roem at this time.
Connect the microphone fer Aute Setup to the Setup Mic
connector on the frent panel of the unit.
........... i
................. _ O ¸_
Place the microphene for Auto Setup at the actual listening
pesition which will be at the same height as yeur ears. Use a
triped or level surface at positioning.
NOTES:
• When using ether microphone see page 28.
il
1
Rell_lote contlol unit/
Select "Auto Setup/Room EQ" at the System Setup Menu.
I
t
I
Fi u "i: o '_ ::_: J; i;i' o o _,_E Q
_I. Auto Setup/Room EQ
2. Speaker Setup
3. Input Setup
4. Advanced Playback
5. Option Setup
Exit
2
Remote contlol unit)
Display the Aute Setup / Roem EQ menu.
21