Denon AVR-2805 Operating Instructions Manual page 23

5 Start the measurements.
Measurement of each channel is performed as folk)ws.
Display
c sw SL
÷
1
Only the front speakers (A) is measured. Even if the front speakers (B)
is set, the setting automatically switches to the front speakers (A) once
measurements are completed.
÷2
Subweofer speaker is measured twice.
•_3 When "ZONE2" is selected, this is net displayed.
After each channel is measured, "Calculating" appears.
The display switches to Auto Setup check screen automatically.
1-I. Auto Setup
I [&_lli [,]#1FIB fl_lz.] I /1_.!
i_ril_l"i'i]l IN
Step: 1/9
_Cancel4
I-I. Auto Setup
Step:9/9
NOTES:
• Measurement is canceled when MASTER VOLUME
is operated while the Auto Setup is performed.
• Set the volume to halfway and set the crossover
frequency to the maximum or Low pass filter off if
your subweefer speaker can adjust the output volume
and the crossover frequency.
1-1. Auto Setup
_Speaker Config. Check
Delay Time Check
Channel Level Check
Store4
Retry 4
Cancel_
Remeasurement starts automatically te receive proper result ef measurement.
Remeasurement is performed to 2 times, and "Retry1 " or "Retry2" is displayed on screen during
remeasurement.
1-1. Auto Setup
ll'lllil! IN
Step: 1/9
_Cancel4
These error screens will be displayed when performing the measurements ef Auto Setup / Room EQ and the automatic measurements can net
be completed because of the speaker arrangement, measurement environment, or other factors. Please check the following matters, reset the
pertinent items, and measure again.
When there is tee much noise in the room, the speakers may net be detected properly. Should this happen, perform the measurements when
the noise level is low, or switch off the power ef the equipment that is [)reducing the noise for the duration of the measurements.
:1 This screen will be displayed when the speakers required for
producing suitable reproduction have not been detected.
• The front L and front R speakers were not properly detected.
• Only one channel of the surround speakers was detected.
• Sound was output from the R channel when only one surround
back speaker was connected,
• The surround back was detected, but the surround speaker was
net detected,
Check that the pertinent speakers are properly connected.
(see page 13)
1-1. Auto Setup
_11_ I1
II!lltllo]t, il
_4Front
ILWB
Retry4
Cancell
2_, This screen will be displayed when the speaker polarity is
connected in reverse.
Check the polarity of the
pertinent speakers.
For some speakers, the
screen below may be
displayed even though
the speakers are properly
connected.
If so, select "Skip_l".
1-1. Auto Setup
"lL:lltll0]lll
_4Front
Retry4
Cancel_
Skip4
:3) This screen will be displayed when accurate measurements
cannot be made due to the input level to the microphone being to()
high.
Set up the speakers so that their position is farther away from
the listening position.
Lower the volume of the subwoofer speaker.
1-1, Auto Setup
_Exit
:4: This screen will be displayed when the measurement microphone
is not connected, or when all ef the speakers have net been
detected.
Connect the measurement microphone to the microphone
connector.
Check the speaker connections.
1-1. A_tup
isr_
Retry4
Cancel4
23