Skip-Over-Perforation; Paper Memory, Overlapping Multi-Part Forms, Multi-Part Forms With Labels; Skip Over Binding; Automatic Tear Off - Epson DFX-5000+ User Manual

Skip-over-perforation

When DIP switch 3-3 is on, the printer inserts a one-inch
margin between the last line printed on one page and the first
line printed on the next page. By adjusting your top-of-form
position, you can get half the margin at the bottom of one page
and half at the top of the next page. See the section on adjusting
the top-of-form position in Chapter 2. Since most application
programs insert their own top and bottom margins, you should
use this feature only if your program does not provide them.
Paper memory, overlapping multi-part forms, multi-part
forms with labels
By setting DIP switches 3-4 through 3-6, you can print on
multi-part forms that vary in thickness. See the section on
using the paper memory feature later in this chapter.

Skip over binding

When DIP switch 3-7 is on, the print head avoids the binding
area along the right and left edges of multi-part forms during
paper feeding, thus avoiding paper jams.
Automatic fear off
When DIP switch 3-8 is on, the printer automatically feeds the
paper to the printer's tear-off edge. To adjust the tear-off
position, use the MICRO FEED buttons to align the paper's
perforation with the printer's tear-off edge. See the section on
adjusting the automatic tear-off position in Chapter 2.
Using the Printer
3-18