Adjusting The Printing Position - Epson DFX-5000+ User Manual

Note:
The red line on the ribbon protector can
when you are in the
fop-of-form position is hidden behind the print ribbon.
5. Press the TOP OF FORM button again to exit top-of-form mode
and save your new top-of-form position. Then close the top
cover.
Note:
If
you enter fop-of-form mode right after loading paper, you can set the
loading and fop-of-form positions at the same time. (When you use the
pull
optional

Adjusting the printing position

If you need to adjust the printing position in the middle of a page,
or to adjust the top-of-form position when using labels, follow the
steps below.
When you move the printing position, you temporarily change the
top-of-form position by
adjust the printing in the middle of the page so that it falls a
half-inch lower,
as well. The printer remembers this temporary top-of-form
position until the next time you load paper, switch tractors, or
turn off the printer.
1. Start printing your document. When you reach the text that you
want to align at a particular spot on the page, press the PAUSE
button to stop printing.
2.
Use
MICRO FEED buttons to adjust the position where you
want
the paper forward or backward in 1/216-inch increments, or
hold it down to move the paper continuously.
fop-of-form
tractor, you cannot adjust the loading position.)
the
the next
line
your next of text to fall. Press the button once to feed
be
mode. At all other times your
same amount. For example, if you
page will begin printing a half-inch lower
Loading and Using Paper
as a
used reference only
2-13