Using Software Programs; Microsoft Windows 3.1 - Epson DFX-5000+ User Manual

7. Plug the other end of the cable into the computer. (If there is
a ground wire at the computer end of the cable, attach it to
the ground connector at the back of the computer.)
Before using the printer's serial interface, you need to select
serial communication by changing the printer's DIP switch
settings. You may also need to change two other serial interface
settings, serial bit rate and parity, before your printer and
computer can communicate properly. See the section on setting
DIP switches in Chapter 3 for more information.

Using Software Programs

To take full advantage of your printer's features, find the
instructions for your software programs below.
Microsoft Windows
®
If Windows is already installed on your system, follow the
steps below to set it up with your printer. Then your printer
will work correctly for all your Windows programs, such as
Word for Windows and Lotus
Note:
If Windows is not already installed on your system, run the setup
program as described in the Windows documentation, and follow steps
4 through 10 below when you reach the section for choosing a printer.
1. In the window labeled Main, double click the Control Panel
icon.
2. Double click the Printers icon.
1-24 Set Up and Print
Caution:
Always close the rear cover before using the printer.
3.1
TM
1-2-3 for Windows.
® ®