Epson DFX-5000+ User Manual page 81

TOP OF FORM
PITCH
PAPER SELECT
FRONT/REAR
Caution:
Never
the printer. Al ways tear off any printed pages or excess paper
so you don't feed more than one page backward through the
printer.
3-6 Using the Printer
Lets you enter and exit the top-of-form
mode so you can adjust the top-of-form
position. The top-of-form position is
where printing begins on each page.
If your printing is too high or low on the
page, you can reset the top-of-form
position by entering top-of-form mode
and using micro feed to adjust the
position. The printer remembers this new
top-of-form position even after it is turned
off, reset, or initialized. Also, the printer
remembers separate top-of-form positions
for the front and rear tractors.
See the section on adjusting the
top-of-form position in Chapter 2.
Lets you select the characters per inch for
printing. Push the button until the light
appears next to your preference. (Your
software setting overrides this setting.)
Lets you select the front or rear tractor. If
you have been using paper loaded on one
tractor, first remove the printed output
before pressing this button to switch the
tractor. When you switch between
tractors, the paper already loaded in the
printer is fed backward to the standby
position and the paper on the newly
selected tractor is loaded.
use the
FRONT/REAR
button when labels are loaded in