Note:
The paper memory feature is available only with the front tractor.
Caution:
When using overlapping multi-part forms, do not press the
TEAR OFF, FRONT/REAR, TOP OF FORM or
reverse-feeding (bottom) MICRO FEED button or a
may result. To remove these forms, tear off the fresh supply at a
perforation below front tractor and press the LF/FF button
to eject the remainingforms.
Saving paper memory settings
This procedure requires setting several DIP switches. See the
section on changing DIP-switch settings earlier in this chapter.
1.
Make sure the printer is turned off.
Turn DIP switch 3-4 off to save your settings for memory
2.
number 1 or on for memory number 2.
Select the page length by turning DIP switches 3-1 and 3-2
3.
on or off as shown below.
Page length
11 inches
12 inches
8.5 inches
70/6 inches
Select the paper type by turning DIP switches 3-5 and 3-6 on
4.
or off as shown below.
3-20
Using the Printer
SW 3-1
OFF
OFF
ON
ON
paper jam
SW 3-2
OFF
ON
OFF
ON