Lexmark Optra Color 1200 Service Manual page 73

5050-001
Service Check" on page
the actuator or sensor. If that doesn't correct the problem, replace
the printer controller board.
Jam 201
Remove the cartridges. Check the registration sensor and the paper
exit sensor. Actuate the sensor lever (flag) and look for a change of
voltage at pin 2 to ground on connectors CN110 and CN124 on the
printer controller board. Look for approximately +5 V. If it works
properly go to the
If it does not work properly, replace the actuator or sensor. If that
doesn't correct the problem, replace the printer controller board. If
the fuser exit rollers do not turn, go to the
Service Check" on page
Jam 202
Check the paper exit sensor by actuating the sensor lever (flag) and
looking for a change of voltage at pin 2 to ground on connector
CN124 on the printer controller board. Look for approximately +5 V.
If it works properly go to the
page 2-32. If it does not work properly, replace the actuator or
sensor. If that doesn't correct the problem, replace the printer
controller board.
24X Paper Jam
Be sure the option paper tray 2 and 3 are plugged in correctly and go
to the "Paper Carrying Service Check" on page
Paper Jam
Be sure there is no paper jammed in the MPF, then go to step 1 of
the "Paper Carrying Service Check" on page
2-32. If it does not work properly, replace
"Paper Carrying Service Check" on page
2-29.
"Paper Carrying Service Check" on
"Drive 2 Stepper Motor
2-32.
2-32.
Diagnostic Information
2-32.
2-31