Lexmark Optra Color 1200 Service Manual page 100

5050-001
To make this adjustment:
Note: Before adjusting the margins, be sure the printer is set to the
graphic print mode in the Print Quality Menu. The Print Quality Menu
is a sub menu of the Color Menu.
1. Select the Diagnostic Mode.
2. Select Printer Setup.
3. Select CMY Top Margin Adjust.
4. Input the values.
To verify the margin values are correct, you must print the Quick Test
page. From the Tray X test screen press Select. While the page is
printing the following message is displayed. The Power indicator
also blinks while the page is printing.
The printer will attempt to print the Top Margin page from the default
paper source. However, if the default source only supports
envelopes, then the page will be printed from Tray 1. The page
consists of alignment diamonds. When you change the value for that
tray you will see the CMY alignment diamonds move up and down
the page. The test page also contains the page count setting, printer
serial number, and code levels.
The Test Page can only be printed for the trays that are installed.
The Menus to change the values show up even if the tray is not
installed. This allows the service person to set these values to the
factory values even if a customer does not have that tray installed.
The Test page should be printed on Letter or A4 paper only.
To exit the Registration menu, press Return.
3-12
Service Manual
Quick Test
Printing...