Quick Disk Test - Lexmark Optra Color 1200 Service Manual

5050-001
P:###### represents the number of times the test has passed
(finished successfully). Initially 000000 is displayed for ######. The
maximum pass count is 999,999.
F:##### represents the number of times the test has failed (finished
with errors). Initially 00000 is displayed for #####. The maximum fail
count is 99,999.
The power indicator blinks indicating the test is in process. The
printer continually runs the same test until cancelled from the
operator panel (by pressing Return or Stop).
Each time the test finishes, the screen is updated with the result. If
the test passes, then the Pass Count increments by 1. However, if
the test fails, then a signal error message is displayed for
approximately 3 seconds and then the Fail Count increments by 1.
Once the maximum pass count or fail count is reached, the test is
stopped, the power indicator is turned on solid, and the final test
results are displayed. Press Return or Stop to exit the test.

Quick Disk Test

Selecting this test runs a disk test that performs a non-destructive
read/write on one block per track on the disk. The test reads one
block on each track, saves the data, and proceeds to write and read
four test patterns to the bytes in the block. If the block is good, then
the saved data is written back to the disk.
The following message is displayed while the test is running. The
Power indicator also blinks while the test is in progress.
If the test passes, the Power indicator is turned on solid and the
following message is displayed. Press Go, Return, or Stop to return
to the DEVICE TESTS screen.
3-20
Service Manual
Quick Disk Test
Testing...
Quick Disk Test
Test Passed