Lexmark Optra Color 1200 Service Manual page 57

5050-001
Print Jobs on Disk?
Files Will be Lost.
Go/Stop?
Invalid Font Data
Invalid Network x
Code
30 color Print Unit
Missing
33 Tray x
Configuration Error
35 Res Save Off
Deficient Memory
Jobs that were spooled to the optional hard disk before
the printer was last turned off have not yet printed.
Press to print the jobs. Press
Go
delete the jobs from the disk without printing them.
You have changed the Job Buffer Size setting from the
operator panel, and the printer must reformat the hard
disk to activate the change. If you press
currently stored on the disk will be deleted. Press
or to cancel this operation.
Return Stop
The printer has detected an incompatibility between
the font data and the firmware. You must download
compatible font data to flash memory before the
printer can return to the ready state.
The code in the specified network adapter has not
been programmed or is invalid. You must download
valid code to the network adapter before the printer
can return to the ready state.
The specified print unit (Cyan, Magenta, Yellow, or
Black) is not installed in the printer. Insert the print unit
and close the top cover to clear the message.
The printer has detected a tray with the rear paper
guide in the wrong position. When loading A4 and
letter size paper, make sure you place it in the tray with
the long-edge of the sheet next to the front of the tray.
Position the rear paper guide correctly for the paper
size, then insert the tray in the printer.
The printer lacks the memory needed to enable the
Resource Save function. This message usually
indicates that too much memory is allocated for one or
more of the printer link buffers.
To disable Resource Save and continue printing, press
.
Go
To enable Resource Save after you get this message:
• Set the link buffer for each interface to Auto, then
exit the menus to activate the link buffer changes.
When the
Ready
Resource Save from the Setup Menu.
• Or, install additional printer memory.
Return
message is displayed, enable
Diagnostic Information
or to
Stop
, all files
Go
2-15