Lexmark Optra Color 1200 Service Manual page 53

5050-001
Ready Hex
Locking Menus
Unlocking Menus
Menus Disabled
Supplies
Maintenance
Parallel
Parallel x
Serial x
Network x
LocalTalk x
Infrared x
Fax
Hex Trace diagnostic mode is active, and the printer is
ready to receive data. Use Hex Trace to isolate the
source of a print job problem. With Hex Trace selected,
all data sent to the printer is printed in hexadecimal
and character representation. Control code strings are
printed, not executed.
To exit Hex Trace mode, turn the printer off or reset the
printer. To reset the printer, press
The Job Menu is displayed and Reset Printer appears
on the second line. Press
Someone has locked the menus. While the menus are
locked, users cannot change the printer default
settings from the operator panel.
Someone has unlocked the menus. Users can now
change the printer default settings from the operator
panel.
Menus have been locked, or disabled. To unlock, press
the Stop and Go buttons as you POR the machine.
At least one of the printer supplies needs attention.
You may have a paper tray that is low on paper or a
toner cartridge or photoconductor that needs
replacing. Press
Menu>
Supplies Menu.
It's time to replace the fuser, transport belt, and roller
set. See the Preventive Maintenance chapter for more
information.
The standard parallel interface is the active
communication link.
The specified parallel interface is the active
communication link.
The specified serial interface is the active
communication link.
The specified network interface is the active
communication link.
The LocalTalk interface is the active communication
link.
The infrared interface is the active communication link.
The Fax interface is the active communication link.
or
Menu>
.
Select
or to open the
<Menu
Diagnostic Information
.
<Menu
2-11