4.2.5.8
Friction/Tractor Sensor Removal
Step 1:
Remove the printer mechanism (Refer to Section 4.2.5. 1.).
Position the paper release lever at its back setting.
Step 2:
Step 3:
Remove the paper feed motor (Refer to Section 4.2.5.7).
Remove the CPS(P) (3 X 10) screw securing the friction/tractor sensor to the side frame R,
Step 4:
then remove the sensor.
Make sure of the sensor direction and set in place before mounting the friction/tractor sensor on
the side frame R.
Side Frame R
Figure 4-27. Friction/Tractor Sensor Removal
ASSEMBLY POINT
(P) (3 x
Sensor
4-21
REV.-A
10)