Paper Loading Roller Unit Removal - Epson Stylus Color 1520 Service Manual

3.2.10.11 Paper Loading Roller Unit Removal

1. Remove the printer mechanism unit. (Refer to Section 3.2.6.)
2. Remove the paper eject frame. (Refer to Section 3.2.10.7.)
3. Remove the CR unit. (Refer to Section 3.2.10.9.)
4. Remove the base frame assembly. (Refer to Section 3.2.10.10.)
5. Attach the knob to the PF roller shaft and press the trigger lever down. Then rotate the paper loading
roller unit by turning the knob clock-wise to hold the edge guide unit down.
6. Remove 1 screw (CBP, 3X8) securing the paper eject drive unit to the left frame assembly, and remove
the paper eject drive unit by lifting up the front edge.
PF Roller Unit
Screw (CBP 3X8)
Left Slide Cover in the
Paper Load Roller Unit
Figure 3-25. Paper Eject Drive Unit Removal
7. Release the joints for the right and left slide covers and the edge guide.
8. Remove the E-ring located at left end of the paper loading roller.
9. Turn the paper loading roller bushing to fit the cutout on the right frame.
10. Disengage the paper loading gear at the right end of the paper loading roller unit from the ASF
transmission gears in the middle frame. Then remove the paper loading roller unit by sliding it toward the
left frame assembly.
Paper Eject Drive Unit
Edge Guide Unit
Disassembly and Assembly
Trigger Lever
Right Slide Cover in the
Paper Load Roller Unit
3-27