Master Programming Level
3.6.3 Zone Setup
PROGRAMMING
1=AUTOPROGRAM
2=POINT PROGRAM
3=ZONE SETUP
Programming Screen #2
ZONE SETUP
1=ENABLE
2=DISABLE
3=ZONE 17 18 19
Zone Setup Screen #1
MS-9050 Series Manual — P/N 52413:F 10/22/2010
Pressing 3 while viewing Programming Screen #2 will access the Zone Setup screens as illustrated
below:
1=ENABLE
2=DISABLE
3=ZONE 17 18 19
1=ZONES INSTALLED
2=ZONES ENABLED
3=ZONES DISABLED
1=ZONE TYPES
2=ZONES AVAILABLE
3=FUTURE USE
Enable
Pressing 1 for Enable, while viewing Zone Setup Screen #1, will display the following screen:
Z
This screens allows the programmer to enable zones, one at a time. A flashing cursor appears next
to the Z, prompting the programmer to enter a two digit zone number (01 - 19). When the second
digit is entered, the zone will be enabled and the cursor returns to the original position next to the Z.
Another zone can then be enabled.
ZONE SETUP
Zone Setup Screen #1
ZONE SETUP
Zone Setup Screen #2
ZONE SETUP
Zone Setup Screen #3
ZONE TO ENABLE
Enable Screen
Programming
85