Zone Assignment - Fire-Lite MS-9050UD Manual

Master Programming Level

Zone Assignment

A maximum of five zones can be programmed to each addressable control module. Pressing 2
while viewing Edit Control Screen #3 displays the following screen:
Note that Z** represents the Zone Number(s) corresponding to this device. The factory default for
an unprogrammed device is Z00 for general alarm zone. A flashing cursor will appear on the first 0
to the left. Enter the two digit number corresponding to the zone that is to be assigned to this
device. The cursor moves to the next Z** designation. Continue entering zone assignments or the
remaining zones can be left blank or programmed as general alarm zones Z00. When all desired
changes have been made, press the Enter key to store the zone assignments. The display will return
to the Edit Control Screen #3.
Adjective/Noun
EDIT CONTROL
1=ADJECTIVE/NOUN
The Adjective/Noun selection allows the programmer to enter specific descriptors about the control
2=DESCRIPTION
module currently being programmed. Pressing 1 while viewing Edit Control Screen #4 will cause
the following screen to be displayed:
Edit Control Screen #4
MS-9050 Series Manual — P/N 52413:F 10/22/2010
ZONE ASSIGNMENT
Z00 Z** Z** Z** Z**
Zone Assignment Screen
1=STANDARD ADJECTIVE
2=STANDARD NOUN
3=CUSTOM ADJECTIVE
4=CUSTOM NOUN
Adjective/Noun Screen
Programming
81