Canon NP6317 Service Manual page 210

CHAPTER 10 TROUBLESHOOTING
16. Paper is not picked up from multifeeder
Cause/Problem
Procedure
area
Sensor arm 1
Pre-registra- 2
tion paper
sensor (Q2)
Multifeeder 3
solenoid
(SL3)
4
Gears 5
DC controller
PCB
17. Registration rollers do not rotate
Cause/Problem
Procedure
area
Belts and 1
gears
Registration 2
roller clutch
(CL1)
DC controller 3
PCB
10-46
Check
Is the arm of the pre-registration paper
sensor (Q2) broken? Does it move
smoothly?
Is the pre-registration paper sensor (Q2)
functioning normally?
Disconnect J311 on the DC controller
PCB. Set the meter to the 1k range. Con-
nect the leads to J311-9 and J311-10 of
part of J311 connected to the wiring. Is the
resistance approx. 145 ?
Is the leading edge of the copy paper
reaching the registration rollers?
Are all drive gears from the main motor
(M1) to the pre-registration rollers nor-
mal?
Check
Are the belts and gears from the main mo-
tor (M1) to the registration roller clutch
(CL1) normal?
Disconnect J307 on the DC controller
PCB. Set the meter to the 1k range. Con-
nect the leads to J307-3 and J307-4 of part
of J307 connected to the wiring. Is the
registance approx. 120 ?
Connect J307 to the DC controller PCB.
Set the meter to the 30VDC range. Con-
nect the (+) lead to J307-3 and the (-) lead
to J307-4. Press the COPY START key.
Does the voltage change from 0V to about
24V?
COPYRIGHT © 1999 CANON INC.
Result
No
No
No
Yes
No
Yes
Result
No
No
No
Yes
CANON NP6317 REV.0 APR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Action
Replace the sensor arm.
Replace pre-registration
paper sensor (Q2).
Check the wiring from
J312 to SL3. If it is nor-
mal, replace the
multifeeder clutch (SL3).
Refer to the sub-section
"Registration rollers do
not turn."
Re-install or replace the
gears.
Replace the DC control-
ler PCB.
Action
Re-install or replace any
belts or gears.
Check the wiring from
J307 to CL1. If it is nor-
mal, replace the registra-
tion roller clutch (CL1).
Replace the DC control-
ler PCB.
Do the registration roll-
ers or drive gears inter-
fere with other parts?
Remove parts from the
vicinity.