Disassembly And Assembly - Canon NP6317 Service Manual

II. DISASSEMBLY AND
ASSEMBLY
This section explains mechanical charac-
teristics and describes how to disassemble/as-
semble the machine.
Be sure to observe the following when-
ever disassembling/assembling the machine:
1. Disconnect the power plug before start-
ing the work.
2. Unless otherwise shown, assemble the
parts by reversing the steps given to disas-
semble them.
3. Identify each screw by type (length, diam-
eter) and location.
4. A washer is used for one of the mounting
screws on the rear cover to protect against
static electricity; be sure to use the washer
when assembling the part.
5. A washer is used for some mounting
screws (for grounding wire, varistor) to
ensure correct electrical continuity; be
sure to use the washer when assembling
the part.
6. As a rule, do not operate the machine
while any of its parts are removed.
7. When sliding out the duplexing unit or the
fixing assembly, be sure to turn off the
front door switch or the power switch.
COPYRIGHT © 1999 CANON INC.
CHAPTER 7 EXTERNAL/AUXILIARY MECHANISMS
CANON NP6317 REV.0 APR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
7-3