Canon NP6317 Service Manual page 178

CHAPTER 10 TROUBLESHOOTING
12. Adjusting Height of the Corona Wires
Corona assembly
Primary corona
assembly
Transfer corona
assembly
Note:
The height (position) of the corona wire of the primary and transfer corona assemblies can be
adjusted by turning the screw at the back of the corona wire.
Turning the screw once causes the height of the corona wire to change by about 0.7 mm.
10-14
Standard position
Figure 10-218
COPYRIGHT © 1999 CANON INC.
Allowable range
±2 mm
Approx. 10.5 mm
±2 mm
Approx. 10 mm
CANON NP6317 REV.0 APR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)