3
2
1
Removing timing chain cover
Removing the Hall-effect signal transmitter
Remove cover (1).
•
Take off gasket (2).
•
Remove Hall-effect signal transmitter (3), noting
•
the semi-circular shim washers.
L
Note:
Mark the correct installed position of the adjusting
washer on the engine block, or remove it in the TDC
position.
Remove gate rotor (4) and take off adjusting
•
washer (5).
5
4
Remove the crankshaft cover
Detach the coolant hose at the water pump and
•
radiator.
Remove the cover.
•
Removing cylinder head cover
Remove the ignition leads.
•
Remove the cylinder head cover.
•
Removing and installing sealing ring in timing
case cover
Drive the sealing ring out with a suitable drift.
•
Drive the sealing ring in from the inside using
•
handle, BMW No. 00 0 500, and drift,
BMW No. 11 1 610.
LT110200
LT110210
11.19