5
4
1
Removing, dismantling and assem-
bling combined oil-water pump
Removing pump
Pull off the wires for the oil pressure and water
•
temperature display at the switch.
Pull the wires out of the housing.
•
Remove housing cover (2) and loosen the gasket
•
with light blows of a plastic-faced hammer.
Remove the housing and loosen the gasket with
•
light blows of a plastic-faced hammer.
Pull off the housing.
•
Dismantling pump
Clamp the pump housing into a vise at the seal-
•
ing faces, using soft jaws.
Remove the impeller (5), holding the pump shaft
•
to prevent it from moving.
Take off the impeller with spacing bushing (6).
•
Pull out pinion (8) and pump shaft (9).
•
Examine the pump housing for damage.
•
6
3
2
8
9
LT110422
11.29