Removing Lever; Removing Guide Bush In Lever; Removing Sliding Piece - BMW K 1100 LT/RS Repair Manual

Removing lever

•
Remove actuator motor.
•
Remove plate.
•
Detach spring.
7
8
•
Release securing element (3) of guide rod (4),
while holding with pin (5).
•
Pull guide rod out of sliding bushing, note
O-rings (6).
•
Remove retainer (7) and press out shaft (8).
•
Install in the reverse order of removal.
L
Note:
The retaining screws are micro-encapsulated and
therefore cannot be re-used. Clean the threads and
the holes. Coat screws with Loctite 243 before in-
serting.
Spray guide rod with silicone spray.

Removing guide bush in lever

•
Remove lever.
3
4
5
6
3
LT460100
•
Loosen locknut (1), unscrew pressure screw (2).
L
Installation:
Only tighten pressure screw such that the guide
bush can still be moved easily, then lock with hexa-
gon nut.
X
Locknut

Removing sliding piece

5
•
Remove actuator motor.
•
Remove plate.
•
Remove lever.
•
Release securing element (3) for sliding piece (4)
on the plate.
•
Remove retaining bracket (5) for tubes.
•
Remove sliding piece completely out of tube.
Note:
Tightening torque:
.......................................................... 7 Nm
4
2
1
LT460110
3
LT460120
46.11