•
Remove taper roller bearing from ring gear with
puller, BMW No. 00 7 500.
00 8 560
•
Remove outer bearing race with internal extrac-
tor, BMW No. 00 8 560.
Installing crown wheel
00 7 500
RS330140
•
Heat housing to 80 °C.
•
Press outer race into bearing seat with drift,
BMW No. 23 4 670, and handle,
BMW No. 00 5 500.
L
Note:
Check that outer race is correctly seated by light
blows.
L
Note:
The tooth backlash must be checked and adjusted
if necessary if new parts have been installed, e.g.
the taper roller bearing.
LT330150
•
Fit existing spacer ring (1) on the crown wheel.
•
Heat taper roller bearing (2) to 80 °C and fit in po-
sition.
•
Install (3).
•
Heat deep groove ball bearing (4) to 80 °C and fit
in position.
00 5 500
23 4 670
LT330160
4
80°C
3
1
2
RT330170
33.13