Installing Cylinder Head - BMW K 1100 LT/RS Repair Manual

Installing cylinder head

Move the piston in cylinder 1 to top dead centre
•
(cylinder 1 = timing end).
Place the cylinder head gasket in position; no
•
holes or passages must be obstructed.
L
Note:
Use only cylinder head bolts with long thread
[from 12/94].
Place the cylinder head in position and insert
•
bolts (1) with washers (2) as far as possible.
11.42
6
8
4
10
Tighten the cylinder head bolts in the order
•
shown.
X
Tightening torque:
Cylinder head bolts ..................................... 20 Nm
Attach tighten angle measuring device,
•
BMW No. 11 2 500, using two T 50 Torx inserts,
BMW No. 00 2 630.
Tighten the cylinder head bolts, to the specified
•
torque and angle, as specified.
Tightening angle................................................ 90°
1
2
LT110640
1 3 9
2
5
7
LT110660