Removing And Installing Shaft Sealing Ring For Gear Selector Drum; Removing And Installing Ball Bearing On Intermediate Shaft; Removing And Installing Bearing Shell For Taper Roller Bearing On Input Shaft - BMW K 1100 LT/RS Repair Manual

Removing and installing shaft sealing
ring for gear selector drum
•
Switch for gear indicator removed.
•
Gear selector drum removed.
00 5 500
23 1 790
•
Lever out shaft sealing ring with screwdriver.
•
Fit shaft sealing ring using drift,
BMW No. 23 1 790 and handle,
BMW No. 00 5 500.
Removing and installing bearing shell
for taper roller bearing on input shaft
00 8 560
00 8 563
•
Heat transmission housing to 100 °C.
•
Remove bearing shell with the aid of support,
BMW No. 00 8 560, and internal extractor,
BMW No. 00 8 563.
•
Fit new bearing shell in transmission housing
while still hot.
•
Drive bearing shell to bottom of seat with drift,
BMW No. 23 1 770, and handle
BMW No. 00 5 500.
23.14
Removing and installing ball bearing
on intermediate shaft
•
The intermediate shaft can only be replaced as a
complete unit.
00 7 500
LT230140
•
Remove ball bearing using universal puller,
BMW No. 00 7 500.
•
To facilitate installation, heat ball bearing to
80 °C.
LT230150
LT230160