Dot1X Pae - Cisco IE-3000-8TC Command Reference Manual

dot1x pae

dot1x pae
Use the dot1x pae interface configuration command to configure the port as an IEEE 802.1x port access
entity (PAE) authenticator. Use the no form of this command to disable IEEE 802.1x authentication on
the port.
Syntax Description
This command has no arguments or keywords.
Defaults
The port is not an IEEE 802.1x PAE authenticator, and IEEE 802.1x authentication is disabled on the
port.
Command Modes
Interface configuration
Command History Release
12.2(44)EX
Usage Guidelines
Use the no dot1x pae interface configuration command to disable IEEE 802.1x authentication on the
port.
When you configure IEEE 802.1x authentication on a port, such as by entering the dot1x port-control
interface configuration command, the switch automatically configures the port as an EEE 802.1x
authenticator. After the no dot1x pae interface configuration command is entered, the Authenticator
PAE operation is disabled.
Examples This example shows how to disable IEEE 802.1x authentication on the port:
Switch(config-if)# no dot1x pae
You can verify your settings by entering the show dot1x or show eap privileged EXEC command.
Related Commands Command
show dot1x
show eap
Cisco IE 3000 Switch Command Reference
2-98
dot1x pae authenticator
no dot1x pae
Modification
This command was introduced.
Chapter 2
Description
Displays IEEE 802.1x statistics, administrative status, and
operational status for the switch or for the specified port.
Displays EAP registration and session information for the
switch or for the specified port.
IE 3000 Switch Cisco IOS Commands
OL-13019-01