Cisco IE-3000-8TC Command Reference Manual page 360

show controllers ethernet-controller
Table 2-20 Receive Field Descriptions (continued)
Field
System FCS error frames
RxPortFifoFull drop
frames
1. FCS = frame check sequence
2. MTU = maximum transmission unit
This is an example of output from the show controllers ethernet-controller phy command for a specific
interface:
Switch# show controllers ethernet-controller gigabitethernet1/1 phy
GigabitEthernet1/1 (gpn: 1, port-number: 1)
-----------------------------------------------------------
General SFP Information
-----------------------------------------------
Identifier
Connector
Transceiver
Encoding
BR_Nominal
Vendor Name
Vendor Part Number
Vendor Revision
Vendor Serial Number
-----------------------------------------------
Other Information
-------------------------------------------------------
Port asic num
Port asic port num
XCVR init completed
Embedded PHY
SFP presence index
SFP iter cnt
SFP failed oper flag
IIC error cnt
IIC error dsb cnt
IIC max sts cnt
Chk for link status
Link Status
Link Status Media
This is an example of output from the show controllers ethernet-controller port-asic configuration
command:
Switch# show controllers ethernet-controller port-asic configuration
========================================================================
Switch 1, PortASIC 0 Registers
------------------------------------------------------------------------
DeviceType
Reset
PmadMicConfig
PmadMicDiag
SupervisorReceiveFifoSramInfo
SupervisorTransmitFifoSramInfo
Cisco IE 3000 Switch Command Reference
2-334
Description
The total number of frames received on an interface that have a valid length (in bytes) but that do
not have the correct FCS values.
The total number of frames received on an interface that are dropped because the ingress queue
is full.
: 0x03
: 0x00
: 0x00 0x00 0x00 0x08 0x00 0x00 0x00 0x00
: 0x01
: 0x0D
: CISCO-METHODE
: SP7041
: 0x43 0x20 0x20 0x20
: 00000MTC1017075F
: 0
: 0
: 0
: not present
: 0
: 30
: 0x0
: 0
: 0
: 50
: 1
: 1
: 2
Chapter 2 IE 3000 Switch Cisco IOS Commands
: 000101BC
: 00000000
: 00000001
: 00000003
: 000007D0 000007D0 40000000
: 000001D0 000001D0 40000000
OL-13019-01