Cisco IE-3000-8TC Command Reference Manual page 622

udld
•
•
Examples
This example shows how to enable UDLD on all fiber-optic interfaces:
Switch(config)# udld enable
You can verify your setting by entering the show udld privileged EXEC command.
Related Commands Command
show udld
udld port
udld reset
Cisco IE 3000 Switch Command Reference
2-596
The no udld port interface configuration command followed by the udld port or udld port
aggressive interface configuration command to re-enable UDLD on the specified interface
The errdisable recovery cause udld and errdisable recovery interval interval global
configuration commands to automatically recover from the UDLD error-disabled state
Description
Displays UDLD administrative and operational status for all ports
or the specified port.
Enables UDLD on an individual interface or prevents a fiber-optic
interface from being enabled by the udld global configuration
command.
Resets all interfaces shut down by UDLD and permits traffic to
again pass through.
Chapter 2 IE 3000 Switch Cisco IOS Commands
OL-13019-01