Errdisable Detect Cause - Cisco IE-3000-8TC Command Reference Manual

Chapter 2 IE 3000 Switch Cisco IOS Commands

errdisable detect cause

Use the errdisable detect cause global configuration command to enable error-disable detection for a
specific cause or all causes. Use the no form of this command to disable the error-disable detection
feature.
For the BPDU guard and port-security features, you can use this command to globally configure the
switch to shut down just the offending VLAN on the port when a violation occurs, instead of shutting
down the entire port.
When the per-VLAN error-disable feature is turned off and a BPDU guard violation occurs, the entire
port is disabled. Use the no form of this command to disable the per-VLAN error-disable feature.
Syntax Description
all
bpduguard shutdown vlan Enable per-VLAN error-disable for BPDU guard.
dhcp-rate-limit
dtp-flap
gbic-invalid
inline-power
link-flap
loopback
pagp-flap
sfp-config-mismatch
Command Default Detection is enabled for all causes. All causes, except for per-VLAN error disabling, are configured to
shut down the entire port.
Command Modes Global configuration
OL-13019-01
errdisable detect cause {all | bpduguard | dhcp-rate-limit | dtp-flap | gbic-invalid | inline-power
| link-flap | loopback | pagp-flap | sfp-config-mismatch}
no errdisable detect cause {all | bpduguard | dhcp-rate-limit | dtp-flap | gbic-invalid |
inline-power | link-flap | loopback | pagp-flap | sfp-config-mismatch}
errdisable detect cause bpduguard shutdown vlan
no errdisable detect cause bpduguard shutdown vlan
Enable error detection for all error-disabled causes.
Enable error detection for DHCP snooping.
Enable error detection for the Dynamic Trunking Protocol (DTP)
flapping.
Enable error detection for an invalid Gigabit Interface Converter (GBIC)
module.
On the IE 3000 switch, this error refers to an invalid small
Note
form-factor pluggable (SFP) module.
Enable error detection for inline power.
Enable error detection for link-state flapping.
Enable error detection for detected loopbacks.
Enable error detection for the Port Aggregation Protocol (PAgP) flap
error-disabled cause.
Enable error detection on an SFP configuration mismatch.
errdisable detect cause
Cisco IE 3000 Switch Command Reference
2-109