Show Udld - Cisco IE-3000-8TC Command Reference Manual

Chapter 2 IE 3000 Switch Cisco IOS Commands

show udld

Use the show udld user EXEC command to display UniDirectional Link Detection (UDLD)
administrative and operational status for all ports or the specified port.
Syntax Description interface-id
| begin
| exclude
| include
expression
Command Modes User EXEC
Command History Release
12.2(44)EX
Usage Guidelines If you do not enter an interface-id, administrative and operational UDLD status for all interfaces appear.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show udld interface-id command. For this display, UDLD is
enabled on both ends of the link, and UDLD detects that the link is bidirectional.
the fields in this display.
Switch> show udld gigabitethernet1/1
Interface gi1/1
---
Port enable administrative configuration setting: Follows device default
Port enable operational state: Enabled
Current bidirectional state: Bidirectional
Current operational state: Advertisement - Single Neighbor detected
Message interval: 60
Time out interval: 5
OL-13019-01
show udld [interface-id] [ | {begin | exclude | include} expression]
(Optional) ID of the interface and port number. Valid interfaces include
physical ports and VLANs. The VLAN range is 1 to 4094.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Entry 1
Expiration time: 146
Device ID: 1
Current neighbor state: Bidirectional
Device name: Switch-A
Port ID: Gi1/1
Neighbor echo 1 device: Switch-B
Neighbor echo 1 port: Gi1/2
Message interval: 5
CDP Device name: Switch-A
Table 2-31
Cisco IE 3000 Switch Command Reference
show udld
describes
2-473