Reassemble The Pc - AT&T Merlin II Feature Module 2 Installation Ans Getting Started Manual

REASSEMBLE THE PC

Check the installation guide that came with the PC again to be sure you have
installed all the necessary components (such as the VDC Card). When you
are satisfied that all components are properly installed, and when you have
inserted the CMS expansion card, reassemble the PC by following this
procedure:
Face the front of the unit and lower the front of the cover so that the rear
1
is slightly higher than the front.
Align the front of the cover with the front of the base (Figure 8). Make
2
sure that the sides of the cover fit within the base of the unit at the front,
and that the plastic tabs at the front of the cover are under the disk drive.
FIGURE 8 Replacing the cover of the PC.
Sides must
fit within
base
Lower the back of the cover onto the base.
3
Slide the cover about 1/8 inch toward the front of the unit.
4
Then, slide the cover toward the rear of the unit. The sides of the cover
5
should now fit within the base, and the top of the cover should extend
slightly beyond the back of the unit.
Tighten the two screws that you previously loosened at the back of the
6
u n i t .
Make sure you have connected the monitor, keyboard, and printer
7
according to the directions that came with the PC.
Plug the PC's power cord into an ac outlet.
8
Step 3: Installing Your Hardware 19