AT&T Merlin II Feature Module 2 Installation Ans Getting Started Manual page 66

When you start call management, CMS is automatically in Day Service mode.
To select Night Service:
Go to the System Status screen.
1
You can reach this screen from the CMS System Menu or from many of
the other call management screens.
Press (labeled "Day/Night").
2 (F1)
The following prompt appears:
DAY/NIGHT: Change to
Type
3 y.
The prompt line reads:
Change to Night Message and Press Any Key to Start Night Service.
Set the voice announcement unit to play the night message.
4
Press any key.
5
Any CMS calls that are active at this point are allowed to complete before
the system switches to Night Service. A message to this effect is
displayed until all calls are completed.
New incoming calls are connected to the night message and then
disconnected. The word
To return to Day Service:
Press (labeled "Day/Night"). on the System Status screen and
1 (F1)
respond to the prompts.
Set the voice announcement unit to play the day message.
2
Night Service? (Y/N): _
replaces the word
NIGHT
Step 9: Managing Calls 61
on the ID line.
DAY