AT&T Merlin II Feature Module 2 Installation Ans Getting Started Manual page 18

Stand in front of the unit and place your hands
2
(Figure 2).
FIGURE 2 Sliding the cover of the PC forward.
Brace the base of the unit against your hip or thigh, and firmly slide the
3
cover toward the front of the unit. (It will move only about 1/8 inch.)
NOTE: The cover fits snugly, and it may be difficult to move out of its
normal position. If the cover does not move, you may have to loosen the
screws a bit more or gently pry the cover forward with the screwdriver.
Place your hands on the sides of the cover toward the rear and tilt it so
4
that the rear section is higher than the front (Figure 3).
FIGURE 3 Removing the cover of the PC.
Lift and remove the cover from the base unit and set it aside.
5
the sides of the cover
on
1/8"
Step 3: Installing Your Hardware 13