Configuring A L2Vpn Ethernet Port - Cisco 6000 Series Configuration Manual

Configuring a L2VPN Ethernet Port

Command or Action
Example:
RP/0/RP0/CPU0:router(config-if)# commit
Step 6 show mac-accounting type location instance
Example:
RP/0/RP0/CPU0:router# show mac-accounting TenGigE
location 0/2/0/4
Configuring a L2VPN Ethernet Port
Use the following procedure to configure an L2VPN Ethernet port.
Note The steps in this procedure configure the L2VPN Ethernet port to operate in port mode.
SUMMARY STEPS
1. configure
2. interface [TenGigE] interface-path-id
3. l2transport
4. l2protocol {cdp | pvst | stp | vtp}{[forward | tunnel][experimental bits]|drop}
5. Do one of the following:
6. show interfaces [TenGigE] interface-path-id
DETAILED STEPS
Command or Action
Step 1 configure
Example:
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
38
• end
• or
• commit
• or
Purpose
• • Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to XR EXEC mode.
• Entering no exits the configuration session and
returns the router to XR EXEC mode without
committing the configuration changes.
• Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
Displays MAC accounting statistics for an interface.
Purpose
Enters XR configuration mode.
Configuring Ethernet Interfaces