Pcl Paper Source Command; Tray Mapping; Mapping Trays To Media - Xerox 6100BD - Phaser Color Laser Printer System Manual

Finishing

PCL paper source command

Tray mapping

Mapping trays to media

5-4
Use the PCL Paper Source command esc 1 # H to program
a PCL print job to use a specific paper. The PCL decomposer
on the DocuSP Controller reads the paper source command
and, using the PCL Paper Sources option in the Queue
Properties and maps the command to the appropriate paper.
The number code corresponds to the following PCL Paper
Source programmed in Queue Properties.
To program the PCL Paper Source, use the following
guidelines:
• Standard: ESC11H
• Manual Paper Feed: ESC13H
• Manual Envelope Feed: ESC13H
• Lower: ESC14H
• Large Capacity: ESC15H
• Envelope Feed: ESC16H
DocuSP allows the operator to select and save tray
mappings for recurring jobs or for jobs needing the same
mapping.
From the Printer GUI, the operator selects [Save Settings].
The dialog box [Save Settings] enables the user to either
select an existing mapping or create a new mapping by
assigning a name and entering a description in the
Comments input area. The operator can also delete
mappings.
To apply the saved mapping to another print run, the operator
accesses the Save Settings dialog box, selects the desired
saved setting and selects [OK]. This action reprograms all the
trays to the values previously stored.
On the DocuSP printer, the media sources are set up for
each queue on the printer interface. The user can map trays
to media in the XPIF job ticket and then use the mapping with
the embedded PCL paper source commands in the data
stream.
System Guide