Backup And Restore Of Tray Settings - Xerox 6100BD - Phaser Color Laser Printer System Manual

Backup and restore of tray settings

System Guide
Once the print job has been sent, the user cannot change
media sources. However, the XPIF job ticket media source to
tray mapping can be overridden for all the trays on the queue.
There are two ways in which an operator can specify the PCL
tray to media mapping:
1. XPIF job ticket. This ticket must be pre-appended to the
job.
2. IPP Attributes. The information in the XPIF ticket and IPP
attributes become part of the job attributes sent to the
system.
The saved mappings can be copied to a different system by
using the DocuSP Configuration Backup/Restore utility from
the System Menu. DocuSP software allows the selection of
individual components to back up and restore.
If a saved mapping contains more trays than the new system
has, the user will be notified but the operation will continue
with only the supported trays programmed. If the mapping
contains fewer trays than those on the new system, the
system will use only those programmed.
In either case, the operator will be notified but the operation
will continue.
NOTE: If the saved mapping contains programming for
stocks that physically cannot be programmed on the new
system, then this is an error and the operation will not
continue.
NOTE: A mapping created on a monochrome or highlight
color system can only be restored on another monochrome
or highlight color system.
Likewise a mapping created for a color system can only be
restored on a full color system.
NOTE: If a mapping requires LCDS stocks MAIN, AUX or
AUTO on a system that does support LCDS, then the
operation will not continue.
Finishing
5-5